Sinotimer Mc101 Manual

This indicates an open-circuit error or input sensor failure. Check that your thermocouple or RTD is wired to the correct terminals (8, 9, 10). Ensure the wires are clean and tightly secured. This can also mean the Sn setting in your menu does not match the actual sensor type attached.

Wire the operating main line source voltage to the device's primary input nodes. On standard builds, this corresponds to and Terminal 2 (Neutral) . 2. Temperature Sensor Configuration MC-101Series

: Keep input signal wiring (thermocouple/RTD) away from high-power load lines to prevent interference. sinotimer mc101 manual

The Sinotimer MC101 digital PID temperature controller is a powerful and cost-effective solution for a wide array of temperature regulation tasks. By understanding its key features, following proper wiring practices, and utilizing functions like Auto-Tune, you can achieve precise and stable control in your projects.

This usually indicates a sensor error. Check your wiring or ensure the sensor type in the settings matches the physical sensor connected. This indicates an open-circuit error or input sensor failure

: Connect to the designated input terminals (often terminals 4 and 5 or 9 and 10).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. This can also mean the Sn setting in

To quickly change the target temperature without entering advanced menus:

The Sinotimer MC101 is equipped with auto-tuning, which automatically calculates the PID parameters ( ) based on your system's thermal characteristics. Set your desired temperature (SV). Enter the parameter menu (hold SET), find . Change ATcap A cap T from 0 to 1. The AT light on the panel will begin flashing.