Motorola Solutions owns the intellectual property of the CPS software. It should be legally acquired through an authorized Motorola dealer or an official Motorola Solutions online account portal.
From unlocking the radio's full potential for wideband or amateur frequencies to programming complex scanning and signaling features, the CPS puts complete control in your hands. The initial setup is the only major hurdle. Once overcome, you will have the ability to maintain, modify, and expand your radio's capabilities for years to come, making the CM140 a long-lasting and valuable asset.
is part of the . It is a Windows-based application that allows users to connect their mobile radio to a computer to: Configure channels, frequencies, and tones (PL/DPL). Set up function buttons (side buttons).
You are likely using the wrong software entirely (e.g., trying to use GP300 or Professional Series CPS). Ensure your software specifically says "Commercial Series" and lists the CM-series mobile radios. Legal and Safety Reminder motorola cm140 programming software
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
To successfully program your Motorola CM140, you need a complete hardware link between your radio and your PC.
Set tight or loose squelch parameters to control background static noise reception. Motorola Solutions owns the intellectual property of the
requires a .
John successfully programmed all 20 CM140 radios using the Motorola CPS software. The radios were then tested and deployed to the public safety agency, who reported no issues with the new configuration.
The radio will typically emit a short beep and restart, indicating the new settings are active. Troubleshooting Common Errors Error Message / Issue Root Cause Wrong COM port selected or missing USB driver. The initial setup is the only major hurdle
Installing the CPS on modern Windows operating systems can be straightforward, but a few key steps are critical for success.
Software alone is insufficient. To program a CM140, you need: A Programming Cable:
RJ45 to USB or DB9 Serial cable (plugs into the microphone socket). Rear Port:
Click on in the top menu, then select COMM Ports . Select the COM port number you verified earlier in Device Manager.